electronic automatic flap barrier turnstile gate

1.Steel cut by laser; 2.The least welding portion polished properly; 3.Original finish kept; 4.Instrusion and safety;

1.production photo

 

2.Technical Data

Technical Data	Unit	DB201
Passage width	mm	600
Throughput rate	p/m	40
Power supply	V(ac)	220~240
Operational voltage	V(dc)	24
Max power consumption	w	32
Frequency	hz	50~60
Prectection level	ip	44
Working temperature		-25~+70
Electro-magnetic drive		DC
Dimension excluding bars	mm	1400x300x980
Net weight including bars	kg	87

3.Metrial Processing 

4.Pure Manual Welding

 5.Pure Manual finishing

6.Fixed Acrylic

   

7.Driver control board

1). The PCB board is developed by our company.

2). The PCB board be processed by listed company .

8.Testing

 1). Check the wiring

When connected power debugging, please check the wiring diagram according to each parts of the line is connected.

Note: protective earth wire of equipment must reliable grounding, otherwise don't allow debugging.

2). Function test

(1) Turnstile actually pick two way signal (come in and out ).  

(2) if the installation has LED indicator light on the surface, if the control PCB board receive the legitimate signal , turnstile will have green arrows in the direction.

9.Package  and  Delivery

 

 10.Warnings

Before starting installation, you must pay attention to those notes:

1.Before starting installation and operation or maintenance, cut off power supply.

2.The product must be earthed, and an earth leakage breaker is necessary on the power supply.

 3.Do not change the original inside wiring.

 4.Keep the automatic control (push-button , remote control , etc) out of the reach of children .The control system must be installed at a minimum height of 1.5mm the ground surface.

 5.Never open the door or the cover of the cabinet when the machine is working .

11.Maintance

1.It is forbidden for those non-specialists to open the cabinet to carry out adjustment, maintenance and service of the product.

2.The housing of the equipment is of a sub-polish stainless steel. It is required to clean regularly with soft cloth so as to keep a clean and polish surface. It is forbidden to clean the surface with a hard object, otherwise, the good looking appearance may be affected. It is also forbidden to wash it with water, otherwise, short circuit may occur in the electric control system and the equipment may be damaged.

3.It is required to check regularly the connection of various movement sections of the equipment to avoid loosen fasteners, otherwise, turnstile failure may be resulted due to long term operation.

4.It is required to apply lubricant regularly to the movement sections.

5.It is required to check regularly the connection socket and connectors of the lines to ensure a reliable connection.

6.It is required to check regularly the protection grounding of the system to ensure a reliable connection.

7.It is required to recover the protection housing of the circuit and close properly the cabinet door after checking and maintaining properly the product.

 

 

8.Project Case

 

9.About us

 

 

                                      Thank you very muck for your view !

 

 

 

Any question , that will be appreciated !

 

 

 

Tel:86-755-29010765

 

 

 

Fax:86-755-29164103

 

 

 

    Mobile:86-13825269270

 

 

 

electronic automatic flap barrier turnstile gate